Husky HME-423E - Manual (Page 62)

B-1
A A p p p p e e n n d d i i x x B B
Troubleshooting
Make sure you are using the right power cord/adapter (DC 12-48V). Do not use power
adapters with DC output higher than 48V. Or it will short circuit the switch.
Select the proper UTP cables to construct your network. Please check that you are using the
right cables. Use unshielded twisted-pair (UTP) or shield twisted-pair (STP) cables for RJ-45
connections: 100Ω Category 3, 4 or 5 cables for 10Mbps connections, and 100Ω Category 5
cables for 100Mbps. Also be sure that the length of any twisted-pair connection does not
exceed 100 meters (328 feet).
Diagnostic LED indicators located on the front panel of the switch can help users to easily
monitor the switch.
IF the power indicator does not light on when the power cord is plugged in, you may have a
problem with power cord. Then check for loose power connections, power losses or surges at
power outlet. IF you still cannot resolve the problem, contact your local dealer for assistance.
If the switch LED indicators are normal, the cables are connected correctly, and the packets
still cannot transmit, please check your system’s Ethernet devices’ configuration or status.