Husky HME-423E - Manual (Page 43)

Configuration Using a Web Browser
4-27
4-6.14.2 Trap Configuration
A trap manager is a management station that receives the trap messages generated by the switch. If no trap
manager is defined, no traps will be issued. To define a management station as a trap manager, assign an IP
address, enter the SNMP community strings, and select the SNMP trap version.
IP Address
This feature allows the administrator to enter the IP address of the trap
manager.
Community
This feature allows the administrator to enter the community strings for
trap stations.
Trap Version This feature allows the administrator to select the SNMP version.
After finishing necessary configurations, click on Apply to save the settings.
4-6.14.3 SNMP v3 Configuration
SNMPv3 primarily added security and remote configuration enhancements to SNMP, including:
z Message integrity to ensure that a packet has not been tampered with in transit.
z Authentication to verify that the message is from a valid source.
z Encryption of packets to prevent snooping by an unauthorized source.
Please follow the steps below to configure SNMP v3 settings.