Husky HME-423E - Manual (Page 12)

Hardware Installations
2-5
3. Check if the DIN-Rail is tightened on the track or not.
4. To remove the switch from the track, reverse steps above.
2-5.1.2 Wall Mounting
Follow the steps below for wall-mounting installation.
1. Remove the DIN-Rail plate from the switch; loosen the screws to remove the DIN-Rail plate.
2. Place the wall mounting plate on the back panel of the switch.
3. Use the screws to screw the wall mounting plates on the switch.
4. Use the hook holes at the corners of the wall mounting plates to place the switch on the wall.
5. To remove the wall mounting plate, reverse the steps above.
2-5.2 Wiring The Power Inputs
Follow the steps below to wire the power inputs.
Be sure to disconnect the power cord before installing and/or wiring your switch.
Be sure of the maximum possible current when wiring connections. If the current goes above
the maximum ratings, the wire could overheat and result in serious damage to your switch.
1. Insert the positive and negative wires of your DC supply into the corresponding V+ and V- contacts of the
terminal block.
2. Tighten the screws to prevent the DC wires from coming detached.