Network management interface, Telnet command line interface, Initiating a telnet session – FARGO electronic HDPii User Manual

Page 117: Network management interface -5, Telnet command line interface -5, Initiating a telnet session -5

Advertising
background image

RESTRICTED USE ONLY

Fargo Electronics, Inc.

HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1)

6-5

Network Management Interface

The SNMP interface is described below.

Interface Description

SNMP

• The Ethernet interface is a fully-manageable SNMP agent that supports

MIB-II.

• The Ethernet interface is MIB II compliant, allowing SNMP managers to

monitor protocol, network and routing statistics.

Telnet Command Line Interface

Initiating a Telnet Session

This procedure shows how to initiate a Telnet session from a PC in order to access the
Telnet services provided by the Printer.

Description

Initiating a
Telnet
session

Follow these instructions to issue Telnet commands.

1. Identify the IP address of your Printer. (Note: See Switching to the

Automatic IP Address Mode.)

2. Initiate a Telnet session from a DOS window on your PC. At the DOS

prompt, enter telnet [IP Address]

Example: C:\>telnet 192.168.11.12
• All Telnet responses from the Printer will then be displayed in the

Telnet session on the PC.

• All commands entered will be sent to the Telnet client in the

Printer.

3. Enter “help” or “?” to get an on-window list of supported Telnet

commands.

Advertising