FARGO electronic HDPii - Manual (Page 190)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1) 7-3
Selecting the Appropriate Printer Driver settings
You have these card selections (to choose from):
• Fargo UltraCard III (Default Card Type)
• Fargo
Ultracard
• HID ISO Prox – Standard (13xx)
• HID ISO Prox – Composite (15xx)
• HID Identity – Standard (IDx20A)
• HID Identity – Composite (HTx20E)
• HID iCLASS – Standard (20xx)
• HID iCLASS – Composite (21xx)
• HID FlexSmart –Standard (14x0)
• HID FlexSmart –Composite (14x6)
• HID FlexSmart Prox – Std (14x1)
• HID FlexSmart Prox – Comp (14x7)
• Indala FlexISO – Standard (FPISO)
• Indala FLexISO XT-Composite (FPIXT)
• Custom
1
• Custom 2
In addition, you have these selections (to choose from):
• Defaults: The Printer Driver software has default Transfer Temperature and Dwell Time
settings that deliver the best transfer for these card types. These defaults automatically
configure based on the card type, Ribbon type and whether printing single- or dual-sided.
• Card Type Selection: Before printing, if using these standard Fargo card types, check
to make sure that the appropriate card type option selected from the Card tab of the
Printer Driver:
• Proper Settings: It is very important to note that not all card types will be
accommodated by these default settings. In some cases, experimentation may be
needed to find the proper settings.