Section 4: accessory procedures, Safety messages (review carefully), Section 4: accessory procedures -1 – FARGO electronic HDPii User Manual

Page 71: Safety messages (review carefully) -1

Advertising
background image

RESTRICTED USE ONLY

Fargo Electronics, Inc.

HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1)

4-1

Section 4: Accessory Procedures

Safety Messages (review carefully)

Symbol

Critical Instructions for Safety purposes

Danger:

Failure to follow these installation guidelines can result in
death or serious injury.

Information that raises potential safety issues is indicated by a
warning symbol (as shown to the left).

To prevent personal injury, refer to the following safety

messages before performing an operation preceded by this
symbol.

To prevent personal injury, always remove the power cord

prior to performing repair procedures, unless otherwise
specified.

Caution:

This device is electrostatically sensitive. It may be damaged if
exposed to static electricity discharges.

Information that raises potential electrostatic safety issues is
indicated by a warning symbol (as shown to the left).

To prevent equipment or media damage, refer to the

following safety messages before performing an operation
preceded by this symbol.

To prevent equipment or media damage, observe all

established Electrostatic Discharge (ESD) procedures while
handling cables in or near the Circuit Board and Printhead
Assemblies.

To prevent equipment or media damage, always wear an

appropriate personal grounding device (e.g., a high quality wrist
strap grounded to avoid potential damage).

To prevent equipment or media damage, always remove the

Ribbon and Cards from the Printer before making any repairs,
unless otherwise specified.

To prevent equipment or media damage, take jewelry off of

fingers and hands, as well as thoroughly clean hands to remove
oil and debris before working on the Printer.

Advertising