FARGO electronic HDPii - Manual (Page 214)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1) 7-27
Adjusting the Ribbon Type
Use the Ribbon Type dropdown menu to match Ribbon type. (Note: The Inhibit or I
designation under YMCI, YMCKI, and YMCKIKI indicates the ability to prevent the transfer of
film to the card surface. Users can select these Ribbon types to prevent film from transferring
over security features, signature panel or other areas of special interest on the card surface.)
Step Procedure
1 Adjust to match the Ribbon Type selection with the Ribbon type that is
loaded in the Printer.
•
YMC (Full Color): Yellow, Magenta, Cyan
OR
•
YMCK (Full Color/Resin Black): Yellow, Magenta, Cyan, Resin Black
OR
•
YMCKK (Full Color/2 Resin Black): Yellow, Magenta, Cyan, Resin
Black, Resin Black
OR
•
YMCKH (Full Color/Resin Black/Heat Seal): Yellow, Magenta, Cyan,
Resin Black, and Heat Seal
OR
•
YMCI (Full Color/Inhibit): Yellow, Magenta, Cyan, Inhibit
OR
•
YMCKI (Full Color/Resin Black/Inhibit): Yellow, Magenta, Cyan,
Resin Black, Inhibit
OR
• YMCKIKI (Full Color/2 Resin Black/2 Inhibit): Yellow, Magenta, Cyan,
Resin Black, Inhibit, Resin Black, Inhibit
Continued on the next page