FARGO electronic HDPii - Manual (Page 270)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1) 7-83
Using the Click and Drag capability
Click and drag the corners and the sides of an area to change size and location of area.
• The Horizontal, Vertical size and X, Y coordinates update accordingly.
Click and drag the area to change the location.
• The X, Y coordinates update accordingly.
Selecting “inches or mm” radio button
Select from the inches or mm radio button to change the measurement type. (Note: This is
similar to the choice on the Card tab.)
• The inches radio button displays the area size and the location in inches.
• The
mm radio button displays the area size and the location in mm.
Using the Add and Delete buttons
Step Procedure
1 Use the Add button for these capabilities:
•
Add an area default sized to .2 (.2 at location “0” with focus on the added
area).
•
Add multiple areas in the same location with the same affect (as if there
were only one area). (Note: Intersecting/overlapping areas do not
cancel each other out; instead, they act as one area.)
2 Using the Delete button to delete the area with focus from the graphic.