FARGO electronic HDPii - Manual (Page 171)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1) 6-59
Restoring the Factory Settings for Ethernet
There may be times when you are unable to use the current configuration of the Ethernet
interface. (Note: This could be because you have lost the password for your Printer or you
just cannot get it to work properly.)
Resetting the settings
The has a menu selection that allows the User names and passwords to revert to default. To
reset these settings, select:
Menu: Setup Printer : Network Settings : Reset Passwords.
Changing the LCD Network Settings
The Printer/encoder will display new menu entries when (a) the Ethernet option is installed
and (b) the Printer has established communications to a host device.
• You can use these procedures to change network settings by using the new LCD menus.
Accessing the Network Setup Menu
Step Procedure
1 Apply power to the Printer.
2 Ensure that the Printer is connected to your network.
3 Wait up to one (1) minute to allow the Printer to configure the IP address.
4 Select Options on the LCD.
5 Select Menu on the LCD.
6 Select the Next button on the LCD until the Network Settings menu entry
appears.
7 Press Select when Network Settings appears on the LCD.