FARGO electronic HDPii - Manual (Page 216)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1) 7-29
Adjusting the Film Type
Step Procedure
1 Allows you to select the film type option that is appropriate for the type of film
currently loaded in the Printer.
• Select
the Clear option to automatically adjust the appropriate transfer
time and temperature to pre-determined defaults. (Note: Select this
option to automatically adjust the transfer temperature (175.0 Celsius)
and the dwell times (2.0 seconds per inch) to defaults when non-custom
card type is chosen on Card tab.)
OR
• Select
the Holographic option to change appropriate internal Printer
settings needed to make the holographic film work. (Note: Select this
option to automatically adjust the transfer temperature (175.0 Celsius)
and the dwell times (2.0 seconds per inch) to defaults when non-custom
card type is chosen on Card tab.)
(Note: It will also adjust the necessary transfer temperature and the
dwell settings in the Driver to provide the optimal holographic InTM
performance.)