Gateway DC-M40 - Manual (Page 85)

S O F T W A R E
85
HOW TO SET UP THE SOFTWARE FOR WINDOWS
Setting up USB driver for Windows
4. After restarting the computer, connect the PC to the camera with the USB
cable.
5. Turn the camera power on with the mode dial set on PC mode.
[Found New Hardware Wizard] will appear and the computer will recognize
the camera.
6. USB Driver installation is complete. After installation,
[Removable Disk] will be displayed in the [My computer] window.
Note
• Before connecting the camera to the PC, you must install the camera driver.
• After driver installation, you have to restart the computer.
• If the camera is connected to the PC before Driver installation, the [Add Found
New Hardware Wizard] will appear. In this case, follow the [Add Found New
Hardware Wizard] to install the camera driver.
When windows search for new drivers in its database on your hard drive,
Select the [Driver Setup] folder by browsing the Application CD.
• Should the computer not find the Camera Driver after installation, try one or
more of the following measures.
1. Delete the camera driver, and re-install the driver.
2. Refer to the FAQ (refer to page 93) to check for a possible solution to the
problem.
• If your PC’s central processing unit is VIA Chip (This is shown in the USB Host
Controller),
Download the patch file from the Gatway web page.
(http://www.gatway.com/).