Gateway DC-M40 - Manual (Page 93)

S O F T W A R E
93
FAQ
About USB
• Check the following if the USB connection malfunctions.
[Case 1] The camera power is off.
Turn the camera power on.
We recommend using an AC power adapter in PC mode. If you use
batteries, check the battery condition.
[Case 2] The mode dial is not set to PC mode.
Rotate the mode dial to PC mode.
PC interfacing is available only in PC mode.
[Case 3] USB Driver is not installed correctly.
Install the USB Driver correctly. Refer to pager 84
[Case 4] The USB cable is not connected or you are using a cable with an
incorrect specification.
Use a USB cable with the correct specification.
[Case 5] The CF CARD is not inserted or the camera can’t recognize the CF
CARD.
The camera power off and insert the CF CARD again.
[Case 6] Occasionally the computer recognizes the USB as another device.
Install the camera driver correctly.
Turn the camera power off and remove the USB cable.
Connect the USB cable again and turn the camera power on.
The computer should now recognize the camera.
[Case 7] There is an unexpected error during file transfer.
Turn the camera power off and on again. Transfer the file again.