IBM 6648 - Manual (Page 149)

Wake on LAN
This setting is used to enable or disable the IBM-developed Wake on LAN
feature. This feature makes it possible for the computer to be turned on
remotely by a network server. Remote network management software must be
used in conjunction with this feature.
To access the Wake on LAN setting, use the following procedure.
1.
Start the Configuration/Setup Utility program. See “Setup Utility
program” on page 122.
2. Select Advanced Power Management.
3. Select Automatic Power On from the program menu.
4. Select Wake on LAN from the Automatic Power On menu.
5. To enable Wake on LAN, select Enabled. To disable Wake on LAN, select
Disabled
.
6. Press Esc until you return to the Configuration/Setup Utility program
menu.
7. Before you exit from the program, select Save Settings from the
Configuration/Setup Utility program menu.
8. To exit from the Configuration/Setup Utility program, press Esc and
follow the instructions on the screen.
System board memory
The following matrix cross-references the name of the computer (printed on
the logo) and the size, speed, and type of memory modules supported in the
computer.
Computers Memory Module
Size Speed Type
Types62696058/6059/6578/6579 64 MB128 MB256
MB 133 MHz SDRAMNon-
ParityIndustry
Standard
Supported memory configuration
DIMM sizes of 64 MB, 128 MB and 256 MB are acceptable. Start filling DIMM
socket 0, then 1. Use 3.3 V unbuffered 133 MHz SDRAM non-parity DIMMs
only.
Chapter 3. Types 6058/6059/6269/6578/6579 135