IBM 6648 - Manual (Page 22)

Diagnostic Error Code FRU/Action
011-013-XXX
011-014-XXX
Serial port Control
Signal/Loopback test failure
1. System board
011-015-XXX Serial port External Loopback
failure
1. Wrap plug
2. System board
011-027-XXX Serial port Configuration/Setup
error
1. Run Setup, enable port
2. Flash the system
3. System board
011-03X-XXX
011-04X-XXX
Serial port failure
1. System board
011-195-XXX Serial port Test aborted by user
1. Information
2. Re-start the test, if necessary
011-196-XXX Serial port test halt, error
threshold exceeded
1. Press F3 to review the log file
2. Re-start the test to reset the log file
011-197-XXX Serial port test warning
1. Make sure the component that is called out is
connected and/or enabled
2. Re-run test
3. Component that is called out in warning statement
4. Component under test
011-198-XXX Serial port test aborted
1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test
3. Go to the ″Undetermined problems″ section
011-199-XXX Serial port test failed, cause
unknown
1. Go to the ″Undetermined problems″ section
2. Flash the system and re-test
3. Replace component under function test
011-2XX-XXX Serial port signal failure
1. External serial device
2. System board
014-000-XXX Parallel port Interface Test Passed
1. No action
014-001-XXX Parallel port Presence
1. Remove external parallel device, if present
2. Run setup, enable port
3. System board
014-002-XXX
014-003-XXX
Parallel port Timeout/Parity error
1. System board
8
Hardware Maintenance Manual: IBM NetVista Computer Types 6058, 6059, 6269, 6568, 6569, 6578, 6579, 6648,
6649