IBM 6648 User Manual
Page 31
Diagnostic Error Code
FRU/Action
086-198-XXX
Mouse Port interface test aborted
1.
If a component is called out, make sure it is
connected and/or enabled
2.
Flash the system and re-test
3.
Go to the
″Undetermined problems″ section
086-199-XXX
Mouse Port interface test failed,
cause unknown
1.
Go to the
″Undetermined problems″ section
2.
Flash the system and re-test
3.
Replace component under function test
089-000-XXX
Microprocessor Test Passed
1.
No action
089-XXX-XXX
Microprocessor failure
1.
Microprocessor(s)
2.
System board
089-195-XXX
Microprocessor Test aborted by
user
1.
Information
2.
Re-start the test, if necessary
089-196-XXX
Microprocessor test halt, error
threshold exceeded
1.
Press F3 to review the log file
2.
Re-start the test to reset the log file
089-197-XXX
Microprocessor test warning
1.
Make sure the component that is called out is
connected and/or enabled
2.
Re-run test
3.
Component that is called out in warning statement
4.
Component under test
089-198-XXX
Microprocessor test aborted
1.
Flash the system and re-test
2.
Go to the
″Undetermined problems″ section
089-199-XXX
Microprocessor test failed, cause
unknown
1.
If a component is called out, make sure it is
connected and/or enabled
2.
Go to the
″Undetermined problems″ section
3.
Flash the system and re-test
4.
Replace component under function test
170-000-XXX
Voltage Sensor(s) Test Passed
1.
No action
170-0XX-XXX
Voltage Sensor(s) failure
1.
Flash system
2.
System board
170-195-XXX
Voltage Sensor(s) Test aborted by
user
1.
Information
2.
Re-start the test, if necessary
170-196-XXX
Voltage Sensor(s) test halt, error
threshold exceeded
1.
Press F3 to review the log file
2.
Re-start the test to reset the log file
Chapter 1. IBM PC Enhanced Diagnostics error codes
17