Intermec 6710 - Manual (Page 181)

SECTION 5
"
Software Download
6710 Access Point User’s Guide 5-21
SetActivePointers
Use SetActivePointers to make inactive access point
segments active, but only immediately before rebooting.
The variable’s format is:
File>
sdvars set setactivepointers
<none|boot|data|both>
The default value is “none.” Setting the value to “boot” or
“data” affects only the given segment. Setting the value to
“both” changes both segments. When the
NextPowerUpTime variable counts down to zero, this field
is checked to see if any inactive segments should be made
active. This value resets to its default of “none” whenever
the access point reboots.
NextPowerUpTime
NextPowerUpTime is a relative time at which to reboot the
access point. The variable’s format is:
File>
sdvars set nextpoweruptime <dd:hh:mm:ss>
The value of this variable is how long into the future the
access point should reboot itself. If you do not want to
reboot the access point after setting this variable, you can
set this variable to zero.
As long as the NextPowerUpTime variable has not counted
to zero on its own, the access point does not reboot. When
the timer does count down to zero, it checks the value of the
SetActivePointers variable, takes the appropriate action as
described above, and then reboots the access point.