Creating a local diag port session – Intermec 6710 User Manual
Page 68
Advertising
SECTION 4
"
Configuration
4-2
6710 Access Point User’s Guide
Only one type of session can be running at a time. For
example, if someone starts a Telnet session while someone
else is configuring the access point through its DIAG port,
the configuration through the DIAG port will terminate.
Creating a Local DIAG Port Session
In summary, you establish a local DIAG port session with
the access point through a VT100 terminal emulation
program. Most general purpose communications software
(such as PROCOMM PLUS) supports this emulation.
To create a session, see Figure 4-1 and the procedure
following it. You should carefully review the procedure first
to become familiar with the process.
Advertising