Intermec 6710 - Manual (Page 71)

SECTION 4
"
Configuration
6710 Access Point User’s Guide 4-5
Accessing the ROM Command
Monitor
1. Set the terminal emulation parameters in your
communications software. If you are configuring this
access point for the first time, set the parameters to
the default settings for ROM mode:
9600, 8N1, full duplex
If you have already changed the default settings, set
the parameters to those you set in ROM mode through
the ROM command monitor.
2. Plug the access point into the outlet. These messages
appear:
QXS6700K <version> <date>
<Press any key within 5 seconds to enter the ROM monitor>
Executing file USTART29.BIN from segment <segment number>
Quickly press a key to perform configuration before startup
Starting system
3. Press any key within 5 seconds of the first ROM
message.
Note that if the access point is in Power-Up Quiet
mode (versus Power-Up Normal mode, the default
setting), the ROM messages do not display. More
information about Power-Up Quiet (PQ) mode and
Power-Up Normal (PN) mode starts on page 5-27 in
Section 5, “Software Download.”
4. See page 5-22 in Section 5, “Software Download,” for
information about the ROM command monitor.