Intermec 6710 - Manual (Page 82)

SECTION 4
"
Configuration
4-16 6710 Access Point User’s Guide
TCP/IP Options
Use [Tcpip] to set options necessary for communications
with this access point, such as IP addresses. Addresses are
required for remote setup or SNMP network management.
Options are:
IP Address 0.0.0.0
IP Subnet Mask 255.255.255.0
IP Router 0.0.0.0
IP Frame Type <DIX>
DHCP <Enabled, if IP address is zero>
DHCP Server Name “Norand DHCP Server”
Auto ARP Minutes 5
IP Address
IP Address is the unique address locally assigned to this
access point. The prompt is:
Range is:
4 nums 0..255
The default is 0.0.0.0, which disables the ability to use
TCP/IP. Following are suggestions for setting the address:
"
If you are installing this access point on an existing
Ethernet segment, you should allocate the IP address
from the same pool as the existing computers on the
segment.
"
If you are installing this access point on a new
Ethernet segment that is not going to connect to the
Internet, try using this Class B address:
172.16.h.h