Intermec 6710 - Manual (Page 45)

6710 Access Point User’s Guide 3-1
Section 3
Installation
" " " " " " " " " " " " " " " " " " " " " " " " " " " "
This section describes how to:
"
Check the access point’s default configuration.
"
Prepare for the installation.
"
Collect the networking equipment you need.
"
Find the best location.
"
Connect to the Ethernet medium.
"
Install PC cards.
"
Apply power.
Checking the Default Configuration
The access point is shipped with default settings for system
software parameters, which are listed in Section 4,
“Configuration.” You may need to change some default
settings to achieve a more efficient configuration for your
site. See Section 4 for information about reconfiguring the
access point. The access point should be properly
configured before it is connected to the network.