SIGMA LBA-708 - Manual (Page 164)

9.3.1.16 Results
This property provides all of the LBA-PC results, except statistics, in a one-dimensional array of
doubles packaged as a Variant.
The results are loaded into the array in the following order:
1. Quantitative
2. Elliptical
3. Gauss Fit – whole beam
4. Gauss Fit – major axis
5. Gauss Fit – minor axis
6. Top Hat – whole beam
7. Top Hat – major axis
8. Top Hat – minor axis
9. Divergence
This is the same order as listed in sections 3.1.15 through 3.1.19 below under individual results
properties (also the same order as displayed in the LBA-PC Results Window). All results values
will be loaded into the array all the time. Results not enabled in the LBA-PC will be zero. Note
there are three sets of Gauss Fit and Top Hat results. Either the whole beam section, or the
major and minor sections will contain valid results depending on how the LBA-PC is configured.
9.3.1.17 Quantitative Results
These properties provide individual Quantitative LBA-PC results. For more information, see
chapter 6 in the LBA-PC Operator’s Manual.
Property Name LBA-PC Result
QuantFrameTotal Total
QuantApertureFrac % in Aperture
QuantPeak Peak
QuantValley Min
QuantPeakLocX Peak Loc X
QuantPeakLocY Peak Loc Y
QuantCentroidX Centroid X
QuantCentroidY Centroid Y
QuantRadius
QuantBeamWidthX Width X (Width Major)
Operator’s Manual LBA-PC 164