SIGMA LBA-708 - Manual (Page 57)

3.2.3.9 Lens
Click on this box if your camera is fitted with a lens. When enabled the 2D image orientation is
adjusted to depict the image as if the observer is standing and viewing the scene from behind
the camera.
When disabled, the 2D image is oriented as if the observer is standing in front of the camera
looking at the surface of the detector.
3.2.3.10 Special Camera Settings
The Special Camera Settings dialog box contains the electronic parameters that define a camera
to the frame grabber board. All of these values are saved inside of a cameras .cam type file.
We are not going to tell you much about these settings because we don’t want you accidentally
changing something important and running amuck. If you want to experiment with a new
camera type, one that is not in our camera selection list, then we recommend that you call our
Service Department and ask for assistance. We’ll be happy to lend a hand.
Notice: If you change a setting here, and then do a Save Config..., the change will be saved with the configuration
file, and be restored when the configuration file is restored.
3.2.4 Capture... define acquisition method and processing
The Capture dialog box is divided into four areas. These four areas each control different aspects of
the image capturing process. Each area will be discussed separately.
Operator’s Manual LBA-PC
Doc. No. 10654-001, Rev 4.10
57