Siemens Simantic Net NCM for Industrial Ethernet S7 - Manual (Page 181)

NCM S7 Diagnostics
181
SIMATIC NET NCM S7 for Industrial Ethernet
C79000-G8976-C129–06
Table 6-1 Meaning of the Menu Commands
Menu Meaning
Options " Customize With this menu command, you set the general parameters for the diagnostic
session.
On Ethernet:
S
Dialog update time
This sets the interval at which the diagnostic data are updated in a
contents area when cyclic updating is selected.
S
Show TSAP in ASCII
You can decide whether the TSAP is shown in ASCII or hexadecimal in
the following tab page dialogs.
Help " You can obtain help about the current diagnostic function As an alternative,
you can also press the F1 key.
Remember that you can also call up context-related help for some of the
diagnostic functions. To obtain help, position the cursor on the output field
and press the F1 key.
Note
If the connection to the CP is terminated during the diagnostic session, the
following message is displayed: “The online connection was terminated”.
You can reestablish the connection to the CP with the corresponding
acknowledgment in the dialog. The connection is then automatically reestablished
whenever possible.