Siemens Simantic Net NCM for Industrial Ethernet S7 - Manual (Page 183)

NCM S7 Diagnostics
183
SIMATIC NET NCM S7 for Industrial Ethernet
C79000-G8976-C129–06
Table 6-2 Possible Settings for the Online Paths – without Parameters for Internetworking
Attachment on
Destination Station
Location of the Module
Rack / Slot
Node Address
Industrial Ethernet MAC address of the Ethernet CP via
which the S7 station is reached.
Entered in hexadecimal.
Rack/slot no. of the CP to be
checked.
If you specify “0/0”, the CP specified
with the node address is accessed
directly.
Industrial Ethernet
TCP/IP IP address of the Industrial Ethernet
CP via which the S7 station is
reached.
Entered in decimal.
Example:
IP address decimal 142.120.9.134
Rack/slot no. of the CP to be
checked.
If you specify “0/0”, the CP specified
with the node address is accessed
directly.
Internetworking
If the CP you want to check with diagnostic functions can only be reached via a
gateway, you must select the device and specify its node address in the local
network.
You must also specify the S7 subnet ID of the destination network:
The subnet ID consists of two numbers separated by a dash:
– One number for the project
– One number for the subnet
You will find the subnet ID in the object properties of the subnet in the STEP 7
project. The subnet ID is also printed out with the network configuration.
Starting Diagnostics from the Properties Dialog of the CP
If the project data are available on your PG/PC, follow the steps outlined below:
1. Select the S7 station in the project and open the hardware configuration (HW
Config).
2. Select the CP and open the Properties dialog.
3. Select the “Diagnostics” dialog.
4. Select the “Run” button.
Result:
NCM S7 Diagnostics is opened. The path is set automatically to match the current
connection in STEP 7.