Sanyo PJLINK PLC-ZM5000L - Manual (Page 15)

1 2 3 Open the battery
compartment lid.
Install new batteries into
the compartment.
Replace the
compartment lid.
Two AAA size
batteries
For correct polarity
(+ and –), be sure
battery terminals are
in contact with pins
in the compartment.
To ensure safe operation, please observe the following precautions :
● Use two (2) AAA or LR03 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean
and install new batteries.
● Risk of an explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions or your local disposal
rule or guidelines.
Point the remote control toward the projector (to
Infrared Remote Receivers) when pressing the buttons.
Maximum operating range for the remote control is
about 16.4’ (5 m) and 60 degrees in front, back and top
of the projector.
Infrared Remote Receivers are provided in front, back
and top of the projector. You can conveniently use all of
the receivers (pp. 10, 11, 59).
16.4’
(5 m)
The remote control can be used as a wired remote
control. Wired remote control helps you use the remote
control outside of the operating range (16.4’/ 5 m).
Connect the remote control and the projector with the
remote control cable (sold separately). Connected with
the remote control cable, the remote control does not
emit wireless signal.
Part Names and Functions
16.4’
(5 m)  Note:
When hanging the projector from the ceiling, select
the Infrared Remote Receiver which is located
farther away from the fluorescent light (p.59).
Remote Control Battery Installation
Wired Remote Control Transmitter
Remote Control Receivers and Operating Range
15