Sanyo PJLINK PLC-ZM5000L - Manual (Page 23)

Connect the projector’s AC power cord into an AC
outlet. The LAMP indicator lights red and the POWER
indicator lights green.
Press the ON/STAND-BY button on the side control
or the ON button on the remote control. The LAMP
indicator dims and the cooling fans start to operate.
The preparation display appears on the screen and
the countdown starts.
2
3
1
The preparation display will disappear
after 30 seconds.
4 After the countdown, the input source that was
selected the last time and the Lamp control status icon
(see page 57) appear on the screen.
Selected Input Source and Lamp control
Complete peripheral connections (with a computer,
VCR, etc.) before turning on the projector.
 Note:
• The Lamp replacement icon and the
Filter replacement or the Filter cartridge
replacement icon may appear on the
screen depending on the usage state of
the projector.
• When the filter cartridge replacement
icon keeps appearing on the screen
at turning on the projector for some
time and no action is taken to replace
the filter cartridge, the projector will be
automatically shut down in 3 minutes
after turning on to protect the projector.
(pp. 66-68, 81)
• When the Picture in Picture function is
set to User 1-5, User 1-5, Input source,
Lamp control status, Lamp replacement
icon and Filter warning icon will appear
on the screen for 10 seconds.
Basic Operation
(See page 57 for Lamp control status.)
Lamp control status
If the projector is locked with a PIN code, PIN code
input dialog box will appear.

Note:
• When the Logo select function is set to Off, the logo will
not be shown on the screen (p.52).
• When Countdown off or Off is selected in the Display
function, the countdown will not be shown on the screen
(p.52).
• When the Input button function is set to Mode 3, the
input signal will be searched automatically (p.51).
• If you press the ON/STAND-BY button on the side
control or the remote control during the countdown
period, you can skip the countdown and go to the normal
operations. In this case, however, the brightness of the
image needs some time to stabilize after turning on the
projector. The display may flicker after turning on the
lamp for the characteristics of the lamp. This is normal
operation and not a malfunction.
After the OK icon disappears, you can
operate the projector.
PIN Code Input Dialog Box
 Note:
• If the PIN code number is not entered
within three minutes after the PIN code
dialog box appears, the projector will be
turned off automatically.
• The "1234" is set as the initial PIN code
at the factory.
Enter a PIN code
Use the Point ▲▼ buttons on the side control or Number
buttons on the remote control to enter a number.
When using side control
Use the Point ▲▼ buttons on the side control to select a
number. Press the Point ► button to fix the number and
move the red frame pointer to the next box. The number
changes to . Repeat this step to complete entering a
four-digit number. After entering the four-digit number,
move the pointer to “Set”. Press the SELECT button so
that you can start to operate the projector.
When using remote control
Press the Number buttons on the remote control to enter
a number (p.14). When you complete entering a four-digit
number, the pointer moves to “Set”. Press the SELECT
button so that you can start to operate the projector.
If you fix an incorrect number, use the Point ◄ button to
move the pointer to the number you want to correct, and
then enter the correct number.
If you entered an incorrect PIN code, “PIN code” and the
number () will turn red for a moment. Enter the
correct PIN code all over again.
Turning On the Projector
Input 1
RGB(PC analog)
16
23