Sanyo PJLINK PLC-ZM5000L - Manual (Page 58)

Choose the running speed of cooling fans from the
following options.
Normal .. Operate in this mode under normal
conditions.
Max ........ Use this mode when you want to increase the
cooling effect when operating the projector in
high ambient temperature environment. Fan
noise is louder than Normal.
Setting
Simple mode buttons
Only these buttons are
active when the simple
mode is set to On. [ON,
STAND-BY, SHUTTER,
INPUT, MENU, AUTO
PC, SCREEN, ▲, ▼
(MUTE), ◄ (VOLUME-),
► (VOLUME+),
SELECT (Mouse Pointer
included), L-CLICK,
R-CLICK, P-TIMER,
POINTER, PIP, ON-OFF
switch] Number buttons
(p.14) also become
active only when setting
the remote control codes
numbers or entering the
PIN code numbers (pp.
54, 62).
Filter control
This function decides whether to activate the simple mode.
Off . . . Simple mode function is off.
On. . . . Only the simple mode buttons are active.
You can replace the filter with this function. Press the
SELECT button at Filter control to display a confirmation
box. To replace, press the SELECT button at yes and the
electrically operated filter starts to scroll.

Note:
• Filter replacement icon and Please wait... message
appear on the screen when the filter is being scrolled.
• The filter cannot be rewound.
• When the filter is replaced, the total accumulated time of
the filter use is automatically set to 0.
A confirmation box appears
and then select yes.
The eight different remote control codes ( Code 1- Code 8)
are assigned to the projector; the factory-set, initial code
( Code 1) and the other seven codes (Code 2 to Code 8).
The same code should be set on both the projector and
the remote control. For example, operating the projector in
Code 7, the remote control code also must be switched to
Code 7.
To change the code for the projector:
Select a remote control code in this Setting Menu.
To change the code for the remote control:
Press and hold the MENU button and a number button
(1-8) on the remote control for more than five seconds to
switch among the codes. See “Remote Control Code” on
page 16.
 Note:
• When different codes are set on the projector and on
the remote control, no operation can be made. In that
case, switch the code on the remote control to fit the
code on the projector.
• If the batteries are removed from the remote control
for a long period of time, the remote control code will
be reset.
Filter control
Fan control
Simple mode
Remote control
 Note:
Warning icon and
Simple mode : On message appear
on the screen for about 4 seconds when press the
button which is not the simple mode button.
58