Sanyo PJLINK PLC-ZM5000L - Manual (Page 44)

Computer Input
This function is used to adjust keystone distortion of the
projected image. Use the Point ▲▼ buttons to choose the
item you want to adjust.
Keystone
This function returns all adjusted values to the factory
default settings. Press the SELECT button at Reset to
display a confirmation box. To reset, press the SELECT
button at yes.
Ceiling
Rear
When this function is set to On, the picture will be top/
bottom and left/right reversed. This function is used to
project the image from a ceiling-mounted projector.
When this function is set to On, the picture will be left/right
reversed. This function is used to project the image from
rear of the screen.
Keystone
Ceiling
Rear
Reset
Adjust the Horizontal/Vertical keystone distortion of the
projected image.
Standard
Corner correction
Adjust the corner distortion of the projected image.
Corner pattern
Choose a Corner pattern mode among Red, White, Blue,
and Off.
Store
Store .... Keep the keystone correction even when the
AC power cord is unplugged.
Reset .... Release the keystone correction when the
AC power cord is unplugged.
Press the KEYSTONE button on the remote control
to switch the Standard (for Vertical/Horizontal) /
Corner correction adjustment. The Standard or Corner
correction adjustment dialog box appears. Use the Point
▲▼◄► buttons to correct the Standard or Corner
distortion (p.31).
Screen aspect
This function is used to project the image to a 4:3 or 16:9
projection screen.
Default (16:10) .... 16:10 is the aspect of the LCD panel.
The original Screen Menu is available.
16:9 ..................... Set to a 16:9 projection screen.
4:3 ........................Set to a 4:3 projection screen.
 Note:
- Natural wide cannot be selected
when 720p, 1035i, 1080i or 1080p is
selected on AV System Menu (p.45).
- When the 16:9 function is selected,
Wide (16:9) is not vailable in the PC
and AV screen (pp.42, 49).
- When the 4:3 function is selected,
Natural wide is not available in the
AV screen (p.49).
44