Sanyo PJLINK PLC-ZM5000L - Manual (Page 31)

Remote Control
POINT
▲▼◄► buttons
KEySTONE button
Basic Operation
If a projected picture still has keystone distortion after
pressing the AUTO PC button on the remote control,
correct the image manually as follows:
Press the KEYSTONE button on the remote control to
switch the Standard (for Vertical/Horizontal) /Corner
correction adjustment. The Standard or Corner correction
adjustment dialog box appears. Use the Point ▲▼◄►
buttons to correct the Standard or Corner distortion. The
Standard or Corner correction adjustment can be stored
(see pages 44, 50).
 Note:
• The white arrows indicate that there is no
correction.
• A red arrow indicates the direction of
correction.
• An arrow disappears at the maximum
correction.
• If you press and hold the KEYSTONE
button for more than 3 seconds while
the Standard or Corner correction dialog
box is being displayed, the Standard
or Corner correction adjustment will be
released.
• The Corner pattern can be set to Off,
Red, White or Blue in the Corner pattern
function. See "Keystone" on pages 44,
50.
• The adjustable range is limited depending
on the input signal.
• Standard and Corner correction functions
cannot be adjusted at the same time. If
one of the functions is adjusted, and then
the other one will be reset automatically.
Reduce the top left corner
part with the Point ►▼
buttons.
Keystone
Reduce the top right corner
part with the Point ◄▼
buttons.
Keystone Keystone
Keystone
Reduce the bottom left
corner part with the Point
►▲ buttons.
Reduce the bottom right
corner part with the Point
◄▲ buttons.
Press the KEYSTONE button on the remote control
to switch Corner correction adjustment, press the
SELECT button on the remote control to select the
corner you want to adjust.
Reduce the right part
with Point ► button.
Reduce the upper width
with the Point ▲ button.
Reduce the left part
with Point ◄ button.
Reduce the lower width
with the Point ▼ button.
Press the
SELECT
button
Press the
SELECT
button
Press the
SELECT
button
Press the
SELECT
button
Keystone Keystone
The top left corner adjustment as an
example:
Press the
Point ▼
button
Press the Point
► button
Keystone Correction
Standard
Corner correction
Keystone
31