Sanyo PJLINK PLC-ZM5000L - Manual (Page 33)

The input source changes each time you press the INPUT button on the side control or the remote
control as follows:
Input 1→ Input 2→ Input 3 → ...
Before using the INPUT button on the side control or the remote control, you must select a correct
input source by On-Screen Menu and the latest input source will be displayed.
Input Selection
Press the INPUT 1, INPUT 2, or INPUT 3 button on the remote control. The input source appears on
the screen as you press each button. Select the connected input source.
INPUT 1 button
Input 1
RGB (PC analog)
RGB (Scart)
HDMI
INPUT 2 button
Input 2
Video
y,Pb/Cb,Pr/Cr
RGB
INPUT 3 button
Input 3
Video
y,Pb/Cb,Pr/Cr
S-video
Side Control
Remote Control
* Only the Input button function is set Mode 1 in the Setting menu, the INPUT button is used for
switching input source. (p.51)
INPUT button *
Direct Operation
Remote Control Operation
Side Control/Remote Control Operation
INPUT 1/2/3 buttons
Remote Control
INPUT button*
RGB (AV HDCP)
RGB (PC digital)
33