Konica Minolta 7075 - Manual (Page 113)

Basic Operations 6-43
Basic Operations
Using the Multi-Sheet Bypass Tray (continued)
Load offset tabbed sheets so that the tab extensions are on the right at the rear (not
front) of the tray. The top sheet is designated face up as the first tab of the finished set.
Subsequent offset tab sheets follow in sequence.
When loading tabbed sheets in the Multi-sheet bypass tray, be sure to specify the paper
type as TAB on the Paper Type/Size Setting Screen; otherwise mishandled paper may
occur. See p. 6-19 to p. 6-21.
Section 1
Introducttion
3rd TABS
2nd TABS
1st TABS
3 FINISHED SETS
ONE FINISHED SET
Example: 9 Tabbed sheets loaded in position for 3 finished sets.
Example: 3 Tabbed sheets loaded in position for one finished set.
Section 1
Introduction 3rd TAB
2nd TAB
1st TAB
Printed
side
Printed
side
Section 1
Introduction
Section 1
Introduction
Section 1
Introduction
1st TAB 2nd TAB
3rd TAB
2nd TAB
3rd TAB
Section 1
Introduction
1st TAB
Rear
Front
Rear
Front