Konica Minolta 7075 - Manual (Page 133)

Output Modes 7-19
Output Modes
Manual Stapling (continued)
CAUTION
When the Booklet tray / Trimmer unit tray capacity is exceeded, the finisher will cease operating. To
avoid such trouble, select an appropriate print quantity from the specifications on p. 7-13.
CAUTION:
When the finisher capacity is exceeded due to the print quantity selected, remove the copied sets as
they exit; otherwise, mishandled paper will occur.
MANUAL OPERATION
Staple Mode
Selection button Staple Start/Stop button
1 Place a set of paper to be stapled into the cover sheet feeder, then align the guide
plate. The indicator light of Staple Start/Stop button will turn green.
NOTE: Refer to the specifications on previous page for available paper size in each mode.
2 Press Staple Mode Selection button to select the desired staple mode.
3 Press Staple Start/Stop button.
Stapled sheets will be delivered to the appropriate tray according to the selected
staple mode.
NOTE: CLOSE THE TRIMMER STACKER COVER; otherwise the machine cannot print/copy.
DO NOT OPEN THE TRIMMER STACKER COVER DURING PRINTING/COPYING; otherwise, the
machine will cease operating and a paper misfeed will occur.
NOTE: If you want to stop the manual stapling operation, press the Staple Start/Stop button again. The
finisher will cease operating. When using Stapling & Folding mode, the unfinished set will be left in
the stacker unit inside the finisher.