Konica Minolta 7075 - Manual (Page 266)

13-42 Key Operator Mode
Key Operator Mode
Memory Switch Setting [13] (continued)
The following functions can be provided by the Memory switch settings.
[1] Auto reset timer
Set the reset interval starting from the completion of a copying job until the machine
returns to the initial condition.
[2] AUTO RESET key function
Set the condition of the following modes when AUTO RESET is pressed; Copy mode,
Copy density, Magnification, Tray selection.
[3] RADF-Original effect
Set the machine condition when original is set on RADF in non-RADF mode with RADF
unit closed.
[4] Job memory auto recall (30)
Job memory No. 30 is automatically recalled when power is turned on or when Auto-
reset is restored.
This job recall function works only when Job No. 30 is registered.
[5] Finisher mode by Full-auto
Set the Finisher mode to be recalled when AUTO RESET is pressed.
[6] Initial by Key counter insert
Set the machine to return to the initial state when Key counter is inserted.
[7] Erasure outside area of original
Set the machine to delete the outside area of original.
[8] RADF frame erasure selection
Set Frame erasure to function anytime in RADF mode.
[9] Automatic tray switching
When paper is depleted during a copying job, the copier continues copying by switching
to another tray that contains the same size paper.
[10] Platen APS
The copier automatically selects the same size copy paper as the original placed on the
platen glass. (In reduction or enlargement mode, an appropriate paper size is selected
according to the ratio selected.)