Kyocera copier - Manual (Page 119)

7-14 Output Modes
Output Modes
Folding and Stapling & Folding Modes (continued)
1 Close the RADF securely, then press [ AUTO RESET ].
2 Touch OUTPUT APPLI. on the Basic Screen to display the Finisher Mode Selection
Screen.
3 Touch STAPLING & FOLDING or FOLDING , as desired.
NOTE: Selecting Folding or Stapling & Folding will automatically switch the output tray to Booklet tray.
Notice that the arrow pointing to the MAIN TRAY shifts to the Booklet tray.
4 Touch OK on the Finisher Mode Selection Screen. The Basic Screen will be restored
and the selection made in the output mode will be reflected in the OUTPUT icon area.
5 Select additional copying features, as required.
NO COVER SHEET of Booklet is automatically selected. To change this selection, touch
APPLI. on the Basic Screen to display the Application Selection Screen, then touch
Booklet twice to display the Booklet Mode Selection Screen to make another selection
or to release the setting.
6 Enter the desired print quantity.
7 Position originals in the document feeder. When using Store mode, see p. 6-28 to p.
6-30.
NOTE: When loading originals, heed the following limits on capacity:
Folding mode 6 pages or less for simplex copying
12 pages or less for duplex copying
Stapling & Folding mode 32 pages or less for simplex copying
64 pages or less for duplex copying
Exceeding the above limits on capacity may cause trouble in the finisher.
8 Press [ START ].
CAUTION
When the Booklet tray capacity is exceeded, the finisher will cease operating. To avoid such trouble,
select an appropriate print quantity from the specifications shown on p. 7-12.