Kyocera copier - Manual (Page 223)

13-10 Key Operator Mode
Key Operator Mode
Copier Initial Setting [2]
Initial settings are the settings that display automatically when the copier is powered on,
when Auto/Reset timer is operated, or when [
AUTO RESET ] key is pressed. These
settings can be changed by the key operator, as shown in this section.
Initially, i.e., at installation, the Basic Screen displays the following condition to meet
Energy Star requirements:
Initial Setting
Copy Mode: 1-1
Copy Density: AES
Lens Mode: 1:1
Paper Tray: APS
Output Mode: offset sort
When Initial settings are changed by the key operator, the new initial settings display
when the copier is powered on, when Auto/Reset timer is reached, or when [
AUTO
RESET ] key is pressed.
The following initial settings can be changed by the key operator:
Copy mode: [RADF; 1-1; 1-2; 2-2; 2-1]
Copy density: [AES; manual]
Lens mode: [AMS; ratio 0.33~4.00]
Paper tray: [APS; trays 1, 2, 3, or 4]
Output mode: [non-sort; group; staple-sort; stapling & folding; folding; cover sheet]
Special original: [Image Quality; Text/Photo Enhance; Special Original; Original Form]
Rotation: OFF
Setting procedures are described on the following pages.
NOTE: The most commonly-used settings are established at installation. Before changing any of the copier
settings, be sure that you understand the overall and long-range effect of the change.