Initial settings, Auto/reset mode, Automatic paper selection (aps) – Kyocera copier User Manual
Page 41: Automatic magnification selection (ams), Automatic exposure selection (aes), Automatic tray switching (ats), Machine information
3-8 Machine Information
Machine Information
Initial Settings
Initial settings represent the initial condition when power is turned on; when ECM
password is set; or when Auto/Reset mode is restored, either manually or automatically.
Print Quantity; 1
Magnification Ratio: 1:1 (key operator setting)
RADF: ON (key operator setting)
Copy mode: 1-1 mode (key operator setting)
AES: (Automatic Exposure Selection) : ON (key operator setting)
APS: (Automatic Paper Selection): ON (key operator setting)
Finisher: Non-sort on Primary (main) exit tray (key operator setting)
Auto/Reset Mode
The Auto/Reset function can be set for OFF/ 30 seconds/ 1 minute/ 1.5 minutes/ 2
minutes/ 2.5 minutes/ 3 minutes/ 3.5 minutes/ 4 minutes/ 4.5 minutes/ 5 minutes by the
key operator. Initially, the mode is set to function after 1 minute of copier inactivity. The
Auto/Reset key function also re-displays the Basic Screen, unless these settings are
changed by the key operator in the Copier Initial Setting Screen. See p. 13-10 to p. 13-
11.
Automatic Paper Selection (APS)
When APS is highlighted on the touch screen, the appropriate copy paper size is
automatically selected. When copying from the platen glass or document feeder, APS
detects the sizes indicated below. For key operator settings of APS, see p. 13-40 to p. 13-45.
PLATEN GLASS: 11"x17", 8.5"x14", 8.5"x11", 8.5"x11"R, 5.5"x8.5"
RADF: 11"x17", 8.5"x14", 8.5"x11", 8.5"x11"R, 5.5"x8.5", 5.5"x8.5"R, A4 (8.27"x11.69",
210mmx297mm)
Automatic Magnification Selection (AMS)
AMS functions automatically when Copy Size is pressed in the Full-Auto mode. An
appropriate ratio is selected, based on the relationship of copy size to original size.
Automatic Exposure Selection (AES)
When AES is highlighted on the touch screen, the appropriate exposure level is
automatically selected to match the copy density of the original. Manual density
adjustments override AES.
Automatic Tray Switching (ATS)
When the selected paper tray becomes empty while copying is in progress, automatic
tray switching detects the same copy paper size loaded in another tray to allow copying
to be continued without interruption. The Multi-sheet bypass tray is not included in tray
switching.