Kyocera copier - Manual (Page 229)

13-16 Key Operator Mode
Key Operator Mode
ECM (Electronic Copy Monitor) Function Setting [4] (continued)
How to Access the ECM Setting Mode
Key Operator Mode Screen ECM Master Key Code Screen
ECM Setting Menu Screen
1 Press [ HELP ] to display the Help Screen, then touch Key Operator Mode .
Enter a 4-digit key operator password, then touch OK to display the Key Operator
Mode Screen. (See note 1.)
If the key operator password is not valid, check with your service representative.
2 Touch [4] E.C.M. function setting . The ECM Master Key Code Screen displays, if a
code is required.
3 Use the keypad on the touch screen to enter your 8-digit ECM master key code, then
touch OK to display the ECM Setting Menu Screen. (See note 2.)
4 Select the desired ECM function, and make settings, as required.
To exit the ECM mode, touch PREVIOUS SCREEN on ECM Setting Menu Screen.
5 To exit the Key Operator mode, touch PREVIOUS SCREEN on the Key Operator Mode
Screen to restore the Basic Screen.
NOTES:
1 If an invalid Key operator password is entered, continue by entering the valid 4-digit password.
2 If an invalid ECM master key code is entered, continue by entering the valid 8-digit code. The ECM
master key code can be set to less than 8 digits by the Memory switch setting of the Key operator
function.