Konica Minolta bizhub 180 - Manual (Page 112)

5.4 Making Copies on Manually Fed Paper 5
bizhub 180 5-19
Be
for
e M
ak
in
g Co
pie
s
Cha
p
ter 5
To copy using the Multi bypass tray
1 Load the document to be copied.
❍ Refer to “ Loading the Document ” on page 3-9 .
2 Adjust the Bypass tray extender and
the paper guides to fit the size of the
paper.
3 Load the paper with the front side
facing down, lightly sliding the paper
as much as possible into the feed slot.
The manual bypass mark ( )
appears in the bottom line of the
screen.
? Are sheets of cards or postcards
loaded?
➜ Make sure that they are not curled
(rolled).
4 Check that “YES/NO” appears in the
bottom line of the screen, and then
press the [No/C] key.
The “PAPER SOURCE SETUP”
menu appears.
✎
Note
“
YES/NO ” is displayed for approximately 5 seconds after paper is loaded
into the Multi bypass tray.
5 Use the and keys to select
the type of paper loaded.
❍ Select from the following four
paper type settings.
“PLAIN”
“OHP”
“CARD”
“ENVELOPE”