Konica Minolta bizhub 180 - Manual (Page 234)

9.1 When Incorrect Copies Are Produced 9
bizhub 180 9-3
T
roub
les
ho
oti
ng
Chap
ter
9
The edge of the copy is dirty. The Document pad is dirty. Clean the Document pad
with a soft cloth dampened
with a mild detergent.
(p. 10-7)
The selected paper size is
larger than the document
(with a Zoom setting of
×
1.00).
Select a copy paper size
that is the same as the size
of the document. (p. 5-30)
Otherwise, select the Auto
Size function to enlarge the
copy to the selected paper
size. (p. 5-31)
The orientation of the
document is different from
the orientation of the copy
(with a Zoom setting of
×
1.00).
Select a copy paper size
that is the same as the size
of the document.
Otherwise, select a copy
orientation that is the same
as the orientation of the
document.
The copy was reduced to a
size smaller than the paper
(with a reduced zoom ratio). Select a zoom ratio that
adjusts the copy size to the
size of the selected paper.
(p. 5-30)
Otherwise, select the Auto
Size function to reduce the
copy to the selected paper
size. (p. 5-31)
The image is not aligned
properly on the paper. The document is not
positioned correctly. Correctly position the
document against the
Document scales. (p. 3-11)
If the Document feeder is
installed, correctly adjust
the Document guide plates
for the size of the
document. (p. 3-9)
The document is not
positioned correctly in the
Document feeder. Lift open the Document
feeder, and correctly
position the document
against the Document
scales. (p. 3-11)
The Document guide plates
are not slid up against the
edges of the document. Slide the Document guide
plates against the edges of
the document.
Curled paper was loaded
into the paper tray. Flatten the paper before
loading it.
Symptom Possible Cause Remedy