Konica Minolta PagePro 1390 MF - Manual (Page 150)

T-40
(4) The 2nd / 1st digits
• It is assigned to indicate detail error description.
Code Status Description Cause Action
000000
Normal
Status
⎯ ⎯ ⎯
000001 Stop
⎯ ⎯ ⎯
Local mechanical error
1xxx11
ADF JAM
during TX
⎯ ⎯ ⎯
1xxx12
ADF Cover
Open during
TX
⎯ ⎯ ⎯
1xxx13
Power Fail
during TX
⎯ ⎯ ⎯
2xxx14
Memory Full
during RX
⎯ ⎯ ⎯
1xxx18 TX Job Lost
⎯ ⎯ ⎯
1xxx19
TX Job
deleted
⎯ ⎯ ⎯
Dial failure
xxxx15
No Dial
Tone
⎯ ⎯ ⎯
xxxx16
Redial All
Failed
(Number
Busy)
⎯ ⎯ ⎯
Comm. Error (at Phase-B)
xxxx31
TX T1
Time Out
• Did not receive any
response from other side
within the time set by
[Connect Time] of
[415. Fax Maintenance] in
Automatic transmission
• Did not receive any
response from other side
within 35 seconds in Man-
ual transmission.
• Automatic
transmission:
1.The fax num-
ber is wrong
2.Response
delay in recep-
tion side
• Manual trans-
mission:
Failure in
remote machine
• Automatic
transmission:
1.Check the fax
number
2.Extension of
Connect Time
• Manual transmis-
sion:
Check the status
of the remote
machine
xxxx32
V8 negotia-
tion Fail
• V.8 negotiation has failed. • Line failure • Retry TX
Comm. Error (at Phase-B)
xxxx40 Retry Out
• Did not receive any
response from other side
after three retries of DCS
(TCF).
• Failure in
remote machine
• Line failure
• Check the status
of the remote
machine
• Retry TX