Konica Minolta PagePro 1390 MF - Manual (Page 95)

S-19
10 Tx Report
Select whether or not a report is
printed after a transmission.
On : Prints the report after each
transmission.
Off : Does not print the report
after each transmission.
Error : Prints the report after a
transmission only if an error
occurred.
• The default setting is Error.
Off On “Error”
11 Redial Count
Select the number of times an auto
redial is attempted. • The default setting is 2
0 1 “2” 3 4 5 6
When the Install Location is set
to “Taiwan”, the choices are
only 0, 1, 2.
If 0 is selected, the auto redial
is not performed.
12 Redial Int.
Select the length of time in sec-
onds (s) or minutes (min) that redi-
als are attempted. • The default setting is 2min.
10s 30s 1min “2min” 3 min
13 Footer
Select whether or not the sender’s
information is printed on received
faxes. • The default setting is Off.
“Off” On
14 DialTone Det
Select whether or not to detect a
dial tone. • The default setting is Off.
“Off” On
15 Fax Main.
Connect
Time Select the amount of
time until the connec-
tion times out. • The default setting is 90
secs.
60 secs 70 secs
80 secs “90 secs”
Tx Level Select the transmis-
sion level. • The default setting is -10dbm.
0dbm 1dbm
-2dbm -10dbm -15dbm
ECM Select whether or not
the automatic error
correction mode
(ECM) is used to auto-
matically send the fax
again if an error occurs
during the transmis-
sion of the document,
for example, due to a
disturbance in the line. • The default setting is On.
OFF “On”
No. Function Purpose Setting Details/Precautions