Konica Minolta PagePro 1390 MF - Manual (Page 151)

T-41
xxxx41
Too many
FTT
• Received Failure to Train
(FTT) from other side
even with the minimum
speed of 2400 bps.
• Failure in
remote machine
• Line failure
• Check the status
of the remote
machine
• Retry TX
xxxx42
Too many
CRP
• Received Command
Repeat (CRP) from other
side more than 3 times
after sending DCS (TCF).
• Failure in
remote machine
• Line failure
• Check the status
of the remote
machine
• Retry TX
xxxx43 T2 Time Out
• Did not receive DCS from
other side within 6 sec-
onds after sending DIS.
• Failure in
remote machine
• Line failure
• Check the status
of the remote
machine
• Retry TX
xxxx44
DCN
received
• Received Disconnect
command (DCN) from
other side at Phase B.
• Failure in
remote machine
• Check the status
of the remote
machine
xxxx45
DTC
Received
• Received Digital Transmit
Command (DTC) from
other side.
• Failure in
remote machine
• Check the status
of the remote
machine
xxxx46
Remote not
capable
for Polling
• Other side was not in Poll-
ing TX when Polling RX.
• Error in opera-
tion on remote
side
• The fax number
is wrong
• Check the Poll-
ing TX setting
of the remote
machine
• Check the fax
number
Comm. Error (at Phase-C)
xxxx50 T2 Time Out
• Did not receive PIX/ECM
from other side within 6
seconds after sending
CFR.
• Failure in
remote machine
• Line failure
• Check the status
of the remote
machine
• Request retry
TX
xxxx51
Image Data
not ready
• Scanner/Encode delayed
in Manual transmission.
• ADF Jam • Clear the ADF
Jam and retry
TX
xxxx52
Phase-C
Time Out
• Cannot be ready for
Image data within 10 sec-
onds after starting Image
transmission.
• System failure • Replace the
Controller/
Image Control
Board (PWB-I)
Comm. Error (at Phase-D)
xxxx60 Retry Out
• Did not receive any
response from other side
after three retries of
(PPS-) Q command.
• Line failure • Retry TX
xxxx61 T2 Time Out
• Did not receive (PPS-) Q
Command from other side
within 6 seconds after
sending PIX/ECM signal
at receiving.
• Failure in
remote machine
• Line failure
• Check the status
of the remote
machine
• Retry TX
Code Status Description Cause Action