Lanier 5415MFD - Manual (Page 129)

More about TX Operation
Enhanced Programming 7 - 13
Setting DEFAULT TX
This function is used to set the default TX mode of the fax unit. Two operations are
available:
1
Press the "Program" key 4 times then the display appears the message TX
OPERATION.
2
Press "5" of Keypad. A message is displayed briefly to confirm your selection.
3
Press the "Left" or "Right Arrow" keys to select MEM. TX or ADF TX as the
default setting. Then press "Yes" key.
4
Press "No/Clear" key, to return to the initial state.
Setting OT-DIAL IN COPY
To prevent the copied original documents in Document Feeding Tray being transmitted
when one-touch key is pressed, this function should be set to "Disable"
1
Press the "Program" key 4 times to display the message TX OPERATION.
2
Press "3" of Keypad. A message is displayed briefly to confirm your selection.
3
Press the "Left" or "Right Arrow" keys to select Disable or Enable as default setting
and press "Yes" key.
4
Press "No/Clear" key, to return to the initial state.
Choices Available Description
Memory TX When set in this mode, documents are scanned into
memory for transmission and dialing starts after the first
pages is scanned (Quick TX).
ADF TX (Direct
Transmission)
When set in this mode, documents are scanned for
transmission after connection has been made to the
receiving unit. (When the available memory is insufficient,
please select ADF TX for a successful transmission)
If line is not available, the message LINE IS BUSY will be
displayed. The facsimile will retry based on the number of
redial attempts and intervals that were preset.