Lanier 5415MFD - Manual (Page 40)

Selecting Paper Tray
2 - 4 Making Copies
Selecting Paper Tray
Paper trays are selected using the "Paper" key. You can select Paper Tray (Tray 1), the Paper Feed
Unit (Tray 2) and the Manual Bypass Tray depending on the configuration of your copy
application. Each tray you select will display on the message display.
Using the Manual Bypass Tray
Use this tray to copy documents onto paper that is not otherwise loaded into the machine or to
copy onto OHP transparencies or special paper types.
Types of Paper
•
Paper and media supported by the Manual Bypass Tray
•
Regular paper: 16-24lb (60-90 g/m2)
•
Thick paper: 24-60lb (90-163 g/m2)
•
OHP transparencies and post cards
Paper Size
•
Maximum: 8.5” x 14” (216mm x 356mm)
•
Minimum: 3.38” x 5.82” (86 mm x 148mm)
Loading Standard Size Paper
When setting documents using plain or thick paper types.
1
Set the original document, using the ADF or the Exposure Glass.
2
Adjust the Document Guide Plates to the original document. Insert the original paper face
up into the tray until it stops.
3
Select the Manual Bypass Tray by pressing the "Paper" key.
4
Press the "Yes" key to accept the standard paper size used for Manual Bypass Tray.
The display shows the Manual Bypass Tray with the standard paper size.
5
Press the "Start" key to perform the copying.
Loading Non-Standard Size Paper
1
Set the original document, using the ADF or the Exposure Glass.
2
Adjust the Document Guide Plates to the original document. Insert the original paper face
up into the tray until it stops.
3
Select the Manual Bypass Tray by pressing the "Paper" key.