Lanier 5415MFD - Manual (Page 57)

Transmitting a Document
Basic Fax Operations 3 - 9
•
To obtain detailed results of a transmission, print the TX Result Report.
Combination Dial Function
When a dial registered as a Combination Dial is used, you can enter the dial number
following the Combination Dial.
Setting a Combination dial:
To register One Touch Dial No. or Speed Dial No. as a Combination Dial, enter the ‘+’
symbol (One Touch Dial key 27[&]) after One Touch Dial number or Speed Dial number.
1
Press "Program" key 3 times.
2
Press ‘2’ of Keypad, then the message “2 SPEED DIAL” appears briefly.
3
Input the Speed Dial No.
4
Input the Fax number by pressing the Keypad.
5
Press the One Touch Dial key 27(&) after the Fax number, the display would shows
the ‘+’ symbol.
6
Press "Yes" key.
The display shows a message to confirm the Speed Dial is programmed as shown.
7
Press the "Reset" key to go back to the initial state.
Using the Combination Dial
1
Place the document into the Document Feeding Tray.
2
Check that the Fax screen is shown. If not, press the "Copy/Fax" key to switch.
3
Press "Speed Dial" key. Enter the NO. which registered as a Combination dial.
•
The display shows the number programmed in Speed Dial, followed by the
symbol ‘+’, indicating that it is a Combination Dial.
4
Enter the other numbers using the dialing as shown:
•
Dial No. (Keypad) + "Start" key
•
One Touch Dial (which has not yet been registered as a Combination Dial)
•
Speed Dial and Keypad
For example: Use the Keypad to input the other numbers(67890) to complete this
combination dial. (The symbol ‘+’ will disappear automatically)
Then press the "Start" key to perform the transmission.
Note: The following applies to Combination Dial.
•
When a One Touch Dial or "Speed Dial" key is used after a Combination Dial,