Paxar 9800 Series - Manual (Page 14)

3-4 Management Methods
T E L N E T i p a d d r e s s
at the UNIX system prompt, where ipaddress is the IP address of the print server.
When you are connected, push RETURN or ENTER to get the "
# " prompt, enter the
password A C C E S S (it will not print), and type anything in response to the E n t e r
U s e r n a m e > prompt. When you get the L o c a l > prompt, you are ready to enter
commands.
XCONFIG. To connect to the print server using the XCD XCONFIG NetWare
utility, insert the XCD Print Server Software diskette in Drive A and type:
A : X C O N F I G
at the DOS system prompt (or choose the appropriate path if you are running
XCONFIG from your CD-ROM or hard drive). If you have only one print server, you
will be immediately connected. If you have more than one print server, you will be
given a list of available print servers. Type the number of the print server to which
you want to connect. When you are connected, enter the password
A C C E S S (it will
not print) at the " # " prompt, and type anything in response to the E n t e r U s e r n a m e >
prompt. When you get the L o c a l > prompt, you are ready to enter commands.
H P J e t A d m i n
The Monarch Print Server works transparently with the HP JetAdmin utility. You
can download JetAdmin from the HP web site
(http://www.hp.com) . Use the
Windows Run command to expand the downloaded file. Then use the Run
command again to execute the
S E T U P . E X E file in the destination directory that you
selected (this file is generally in the D I S K 1 subdirectory) and begin the installation.
Follow the instructions on the screen to complete the installation.
NOTE: Windows 98 requires either JetAdmin V2.54 (this version can be installed
from the Microsoft Windows 98 CD by running the SETUP.EXE file in the
DRIVERS/PRINTERS/JETADMIN/DISK1/
directory) or V3.30 or later
(available on the HP web site).
The print server will appear in the list of configured print servers unless IPX is not
running on the computer and the print server is not configured with a valid IP
address. If this is the case, then select Device from the menu bar and click on
New. Select the desired print server from the list of unconfigured devices and then
press Configure. Enter the requested information, including the IP address, subnet
mask, and gateway. Then click Close to return to the list of configured print
servers.
You may now select the print server from the list and click on the Modify button (or
select Device and then Modify from the menu bar) to change the print server
configuration.