Paxar 9800 Series - Manual (Page 67)

Command Summary A-1
C O M M A N D S U M M A R Y
G e n e r a l C o m m a n d s
Although it is not normally necessary to change the print server default parameters,
you can change the configuration through any following methods:
♦
TELNET
♦
XCD XCONFIG NetWare Utility
♦
Remote Console accessed through Xadmin32 or Web XAdmin
The general configuration procedure is the same regardless of which method is
used.
Certain print server NetWare parameters (such as the NetWare service name) can
also be changed by using the Hewlett-Packard JetAdmin utility or XCD XAdmin
utility.
T E L N E T
To connect to the print server using TELNET on UNIX, Windows NT, or most other
TCP/IP systems, type:
T E L N E T i p a d d r e s s
at the UNIX system prompt, where ipaddress is the IP address of the print server.
When you are connected, push RETURN or ENTER to get the "
# " prompt, enter the
password A C C E S S (it will not print), and type anything in response to the E n t e r
U s e r n a m e > prompt. When you get the L o c a l > prompt, you are ready to enter
commands.
X C O N F I G
To connect to the print server using the XCD XCONFIG NetWare utility, insert the
XCD Print Server Software diskette in Drive A and type:
A : X C O N F I G
at the DOS system prompt. If you have only one print server, you will be
immediately connected. If you have more than one print server, you will be given a
list of available print servers. Type the number of the print server to which you
want to connect. When you are connected, When you are connected, enter the
A