Paxar 9800 Series - Manual (Page 57)

DLC/LLC Configuration 9-1
D L C / L L C C O N F I G U R A T I O N
O v e r v i e w
The Monarch print server supports the DLC/LLC protocol, a simple protocol that is
supported on a wide range of network operating systems (refer to chapter 1 for
specific print server protocol support information). DLC/LLC is included as a
standard part of Windows NT and Windows NT AS. It can be used on other
systems with the addition of vendor supplied software that supports the Hewlett-
Packard JetDirect card.
C o n f i g u r i n g D L C / L L C o n W i n d o w s N T
To use DLC/LLC on Windows NT, you must first install the DLC protocol:
1. Go to the NT Control Panel and double click on the Network icon.
2. Click Add Software
3. On Windows NT 3.xx systems, select Add Software. On Windows NT 4.xx
systems, click on the Protocols tab, and click Add.
4. Select DLC Protocol. Click Continue (for 3.xx systems) or Close (for 4.xx
systems).
5. Reboot your system to make the change take effect.
Windows NT 4.xx Printer Setup
1. From the Start menu, select Settings and then Printers. Double click on Add
Printer.
2. Select My Computer and then click Next.
3. Select Add a Port.
4. Select Hewlett-Packard Network Port and then click New Port
5. A list of available print server Ethernet addresses appears in the larger box
under Card Address. Select the address of the desired print server (the
address is on the label affixed to the print server, or it can be gotten through
the self-test page). The selected print server address will then appear in the
smaller box under Card Address.
9