Paxar 9800 Series - Manual (Page 37)

Novell Network Configuration 5-9
7. Exit NWAdmin. You are now ready to use the print queue from a NetWare
workstation.
C o n f i g u r i n g t h e P r i n t S e r v e r a n d P r i n t Q u e u e U s i n g
P C O N S O L E a n d X C O N F I G ( Q u e u e S e r v e r M o d e )
As an alternative to JetAdmin and XAdmin, you can use the standard Novell
PCONSOLE utility in conjunction with the XCONFIG program to set up your print
queues. The procedure is basically as follows:
1. Use XCONFIG to connect to the print server. Enter the password (ACCESS is
the default) and type anything in response to the Enter Username> prompt.
2. If you are configuring an NDS queue, enter the commands:
S E T S E R V I C E s e r v i c e n a m e T R E E t r e e n a m e
S E T S E R V I C E s e r v i c e n a m e C O N T E X T c o n t e x t n a m e
where servicename is the service that you want to configure (the default
service names are listed in the Default Print Server Names section at the
beginning of this chapter), treename is the name of your NDS tree, and
contextname is the NDS context where the print server will reside. Now skip to
step 3.
If you are configuring a bindery queue, enter the command:
SET NETW QSERVER fileserver ON servicename
where fileserver is the name of the file server where the queue will reside (note
that this is not necessarily the same as the volume name), and servicename is
the name of the print server service (the default service names are listed in the
Default Print Server Names section at the beginning of this chapter).
NOTE: The SET NETWARE SERVER command, which enables file servers
on a global basis, is available for compatibility with older firmware
releases, but is not recommended for new applications.
3. Start PCONSOLE
♦
If necessary, change to the desired context if you are using NDS.
♦ Go to Print Queues, press Insert to create a new print queue, and
enter the name of the print queue. If you are configuring an NDS
queue, you will also need to enter a volume name (press Insert to
browse for available volumes).