Paxar 9800 Series - Manual (Page 68)

A-2 Command Summary
password A C C E S S (it will not print) at the " # " prompt, and type anything in response
to the E n t e r U s e r n a m e > prompt. When you get the L o c a l > prompt, you are ready
to enter commands.
G E N E R A L S E R V E R C O M M A N D S
C l e a r F a t a l Deletes fatal error log
C l e a r P a s s w o r d Remove console password
C l e a r P o r t p o r t n a m e J O B Clears current entry in the print server's
internal queue for the specified portname
C l e a r S e r v e r S t r i n g n Remove BOT/EOT string
E X I T / ^ D Exits print server console
H e l p Provides information on available
commands
S E T D E F A U L T Sets print server parameters to factory
defaults
S E T L O A D D i s a b l e Disables firmware reload after exit
S E T L O A D E n a b l e Enables firmware reload after exit
S E T L O A D H o s t < n a m e > Sets node name of boot host for
(NetWare firmware load)
S E T L O A D I P a a . b b . c c . d d Sets IP address of load host (TCP/IP
firmware load)
S E T L O A D S o f t w a r e < f i l e n a m e > Sets host filename of firmware to load
S E T P a s s w o r d < p a s s w o r d > Sets console password (default password
is ACCESS)
S E T P O R T < p a r a l l e l p o r t n a m e > B I D i r
[ E N | D I S ]
Enables/disables bidirectional
communications on parallel port, where
<portname> is P1 for first parallel port or
P2 for second parallel port
S E T P O R T < p a r a l l e l p o r t n a m e > D M A
[ E N | D I S ]
Enables/disables DMA support on
parallel port (not available on Pony Print
Server Plus or XConnect II Lite)
S E T P O R T < p a r a l l e l p o r t n a m e > F S T B
[ E N | D I S ]
Enables/disables fast strobe mode
support on parallel port
S E T P O R T < p a r a l l e l p o r t n a m e > N B U F
[ E N | D I S ]
Enables/disables no buffer support on
parallel port